@PhilGrimley this is my b2, under bright light, with the flash on (it's tiny, tho). Some extremely black paint! #makerslife

Struggling with thread measurements for your 3D-printed caps? 🛠️ Our step-by-step guide ensures a perfect fit every time! Learn about tools, techniques, and pro tips. #3DPrinting #ThreadDesign #MakersLife

https://bdking71.wordpress.com/2025/01/03/mastering-thread-measurements-for-3d-printing-caps-a-step-by-step-guide/

Having a homemade cappuccino in my new favorite mug.

Best part of being a maker is when you can make something for yourself that brings joy. And a morning smirk.

#Pottery
#Ceramics
#MakersLife

I'm quite pleased with these plates. Because I make them from a prepared slab of clay that is then shaped on the wheel & the rim turned up, they do not require the addition of water with the resultant problems with uneven drying that can cause cracking.

I also don't make a foot ring because I prefer the simple & grounded look of these.

I've had a lot better outcomes (no cracking or warping) using this method than with throwing/trimming plates.

#DragonBellyCeramics
#MakersLife

Finally removed the dead upright freezer from my shop today and replaced it with shelves. Sucked up a HUGE lot of the clutter that's been logjamming the shop, and opens room to complete other projects, like putting another hardware cabinet on the rear wall, and installing a lumber rack to the front wall, which will suck up some of the stuff stored vertically to the left of the shelves. I haven't seen so much uncovered floor space in years, and I'm just getting started with the reorganization.

#makerslife #makers #workspace #workshop #tools #materials