Rack Splitter/Router with FX Loop & XLR out.
This is a custom splitter/router with FX Loop that can handle signals ranging from instrument level up to higher line level.

It is equipped with 4 TS inputs, 4 TS outputs, 1 FX Loop (2xTS), a Tuner-out and a Balanced XLR-out.
By using the respective rotary switch you can select which input and which output will be active each time. (check flow chart).

It features high-impedance inputs (buffered with JFET, low noise Op Amps) that can be driven either by instruments (guitar, bass etc) or line level signals as well.
The output impedance is very low, ensuring the best interconnectivity with the rest of your gear.

The circuit is built around low noise, low distortion OP amps and is equipped with input filters in order to reject external RF interference.
It requires a typical 9V power supply and can take up to 24V (max).
The higher the voltage the larger the available headroom.

Headroom vs supply:
~6Vpp@9V
~10Vpp@12V
~16Vpp@18V~22Vpp@24V

- Input impedance: 3.3MΩ
- Output impedance: 100Ω
- Balanced output impedance: 150Ω
- Flat Frequency response on the whole span of the audio spectrum.
- Required power supply: 9-24 Volt DC
- Current draw: 12mA @ 9Volts
- Enclosure dimensions: 19" 1U 431x203x43mm
- Weight: 1055gr

#dpfx #dpfxpedals #racksplitter #splitterrouter #signalsplitter #rack1u #1urack #rackenclosure #guitarsplitter #guitarpedals #basssplitter #basspedals #inputselector #outputselector #handmadepedals #handmadeeffects #rackaudio #rackeffects #boutiquepedals #boutiqueeffects

Triple Splitter (1 normal + 2 Isolated) + 1 balanced XLR output.
Suitable for both bass and guitar or any other instrument with similar pickups.

This buffered splitter has three TS (6.35mm) outputs with 2 of them being isolated using audio transformers, also equipped with Phase-Reverse switches (180˚), both compatible with either balanced or unbalanced equipment. Output-1 has a common ground with the Input.

The 4th output is offered in balanced mode via the XLR connector which is equipped with a ground-lift switch.

- Voltage Required: DC 9-18 Volt (using 12-18V gives you more headroom)
- Max Current draw: 12mA @ 9V
- Input impedance: 3.3MΩ
- Output impedance: < 1kΩ
- Equipped with indicative LEDs to show you when the pedal is powered.

#splitter #isolatedsplitter #displitter #dibox #groundloopnoiseisolator #biamp #dpFX #dpFXpedals #handpaintedpedals #boutiquepedals #handmadepedals #signalsplitter #triplesplitter #xlrout #xlr #xlrsplitter #handmade #handmadepedals