Lmst

Browning BL22 – Test plates to check the bolt closure (misfires)
The misfires in the Browning BL-22 were caused by a locking plate that was no longer within the correct dimensions. This issue is well documented on this website. At one point, I 3D printed a few test plates, which made it easy to measure and determine the proper dimensions needed to eliminate the excess…
---
https://3xn.nl/projects/2025/05/30/browning-bl22-test-plates-to-check-the-bolt-closure-misfires/
---
#Bl22 #bl22 #bolt #browning #misfire #repair #tinkercad

three plates next to each other, with the number 20, 21, 22 indicating the length of each plate.

[FIXED?] Browning BL-22 misfires
Next to some other issues that I have with my Browning BL22 is that it very often misfires. And after a lot of thinking, trial and error, I think I have found the issue. Remember the post about the little plate that came loose? The misfires are related to this as far as I have been able to figure out. There is a locking block that locks itself via this little plate. …
---
https://3xn.nl/projects/2025/03/11/fixed-browning-bl-22-misfires/
---
#bl22 #browning #fixed #misfire

[FIXED] Browning BL-22 Bolt Fault
It is the second time that I have to fix this issue where the trigger fails to release the hammer. Symptom: The lever is not closing completely and then you cannot pull the trigger. Cause: There is a small piece of steel in the “roof” of the action that has come loose and slides forward. Fix: Fix the steel insert in its place, now with a…
---
https://3xn.nl/projects/2024/08/01/fixed-browning-bl-22-bolt-fault/
---
#action #bl22 #bolt #browning #DIY #misfire #repair #rifle

the inside of the action of a browning bl22 rifle.

looking inside the action housing of the browning, you can now see a thoroughly cleaned out slot where the insert goes into.

this is the insert of the browning rifle that has come loose. when it does this, the lever will not close and you cannot pull the trigger.

one can now see two green drops of loctite in the roof of the action housing.

Fixing an issue with my Browning BL22 (Lever not closing)
After cleaning out my Browning BL22 and replacing some springs, I experienced an issue with the lever on a regular basis. I took it apart again, checked everything, only to have it re-appear again. Then I noticed that a small plate in the roof of the rifle’s action housing had come loose. After some investigating, I deduced th…
---
https://3xn.nl/projects/2024/05/19/fixing-an-issue-with-my-browning-bl22-lever-not-closing/
---
#bl22 #browning #lever #loctite #repair #rifle

#bl22

Client Info