Big Benchy Is a Boat That Really Boats https://hackaday.com/2024/09/02/big-benchy-is-a-boat-that-really-boats/ #3dPrinterhacks #trollingmotor #3dprinted #3dprinter #bigbenchy #Benchy #boat

Solar Boat Makes Waves https://hackaday.com/2023/08/11/solar-boat-makes-waves/ #TransportationHacks #trollingmotor #batterybank #sailboat #solar #boat

Autonomous Inflatable Canoe

With the summer months nearly upon us, many are dreaming of warm afternoons spent floating on a quiet lake. Unless you're [Kolins] anyway. Apparently his idea of a good time is controlling a full-sized inflatable canoe not from onboard with a pair of oars, but from the shore with a RC transmitter.

The linkage design allows the motor to be adjusted vertically.

Of course, as the video after the break shows, just because the canoe is powered by a remotely operated electric trolling motor doesn't mean it can't still carry human occupants. In fact, with the addition of a Matek F405-Wing flight controller running the rover variant of ArduPilot, the boat can even take you on a little tour of the lake while you kick back and relax.

We like that this project took the path of least resistance wherever possible. Rather than trying to spin up his own custom propulsion unit, and inevitably dealing with the challenge of waterproofing it, [Kolins] built his system around a commercial trolling motor. A clever servo mechanism physically turns the motor in much the same way a human operator would, while the speed is controlled with a suitably beefy ESC from Traxxas placed between the motor and its lead-acid battery.

It doesn't look like there's been any permanent mechanical or electrical changes made to the motor, which makes the whole thing a lot easier to replicate. We've talked in the past about the relative rarity of low-cost robotic watercraft, so a "bolt-on" propulsion module like this that can turn a cheap inflatable boat into an autonomous platform for research and experimentation is very interesting.

Thanks to [Neolker] for the tip.

#robotshacks #transportationhacks #ardupilot #remotecontrolled #trollingmotor #watercraft

Open Source Autopilot For Cheap Trolling Motors

Quiet electric trolling motors are great for gliding into your favorite fishing spot but require constant correction if wind and water currents are at play. As an alternative to expensive commercial GPS-guided trolling motors, [AlexAsplund] created Vanchor, an open source system for adding autopilot to a cheap trolling motor.

To autonomously control an off-the-shelf trolling motor, [Alex] designed a 3D printed steering unit powered by a stepper motor to attach to the original transom mount over the motor's vertical shaft. A collar screwed to the shaft locks the motor into the steering unit when the motor is lowered. The main controller is a Raspberry Pi, which hosts a WiFi hotspot and web server for control and configuration using a smartphone. Using navigation data from an e-compass sensor and a marine GPS chart plotter, it can hold position, travel in a specified direction, or follow a defined route. [Alex] is also planning to add the option of using a GPS module instead of a commercial plotter.

For an estimated total of $300, including the motor, this seems like a viable alternative to commercial systems. Of course, it might be possible to add even more features by integrating the open source ArduRover autopilot, as we've seen [rctestflight] do on multiple autonomous vessels. You can also build your own open source chart plotter using OpenCPN, which rivals commercial offerings.

#transportationhacks #autonomousboat #fishing #marinepropulsion #trollingmotor