Fabbed a GPU bracket on my lunch break, and it works quite well! The Sapphire 9070XT has three threaded inserts on the back of the card, and the case has numerous small holes along the front edge. Since the clearance was so tight (precisely 12mm) I just printed a single flat piece with two inserts and three through-holes with recesses for screw heads (one recess is missing because I thought I could put a screw through a hole in the case, through my bracket, and into the threaded insert on the GPU - but it didn't quite line up). The end result is two screws holding the bracket to the GPU, and two screws holding the bracket to the case. Since it's on the opposite end of the GPU it does an amazing job of stabilizing everything.
I even personalized the bracket a bit with a Delta symbol!
#3Dprinting #computer #hardware #pc